Skip to main content

OneTouch Ultra Plus Flex™ - Preparing For A Blood Glucose Test – Notes And Cautions

Published 2025-03-26
Updated 2025-10-15
Products OT Delica Plus Lancet OT Delica Plus Lancing Device OT Ultra Plus Flex Meter OT Ultra Plus Test Strip
Testing Your Blood Glucose:

Preparing For A Blood Glucose Test:

 

  • Have these things ready when you test:
    • OneTouch Ultra Plus Flex™ Meter
    • OneTouch Ultra Plus™ Test Strips
    • Lancing device
    • Sterile lancets
  • NOTE:
    • Use only OneTouch Ultra Plus™ Test Strips.
    • Unlike some blood glucose meters, no separate step to code your OneTouch Ultra Plus Flex™ System is required.
    • Testing must be done within operating temperature range (50-104°F) and 10-90% non-condensing relative humidity.
    • Make sure your meter and test strips are about the same temperature before you test.
    • Keep test strips in a cool, dry place between 41°F and 86°F and below 65% relative humidity.
    • Do Not test if there is condensation (water build-up) on your meter. Move your meter and test strips to a cool, dry spot and wait for the meter surface to dry before testing.
    • Do Not open the test strip vial until you are ready to remove a test strip and perform a test. Use the test strip immediately after removing it from the vial.
    • Tightly close the cap on the vial immediately after use to avoid contamination and damage.
    • Store unused test strips only in their original vial.
    • Do Not return the used test strip to the vial after performing a test.
    • Do Not re-use a test strip that had blood, control solution, or any contaminants applied to it. Test strips are for single use only.
    • With clean, dry hands, you may touch the test strip anywhere on its surface. Do Not bend, cut or modify the test strip in any way.
    • When you first open a vial of test strips, record the discard date on the label. Refer to the test strip insert or vial label for instructions on determining the discard date.
    • Comparing your blood glucose test results taken with this meter to your results taken from a different meter is not recommended. Results may differ between meters and are not a useful measure of whether your meter is working properly.
  • CAUTION:
    • Do Not use your test strips if your vial is damaged or left open to air. This could lead to error messages or inaccurate results. Contact Customer Care immediately if the test strip vial is damaged.
    • If you cannot test due to a problem with your testing supplies, contact your healthcare professional. Failure to test could delay treatment decisions and lead to a serious medical condition.
    • The test strip vial contains drying agents that are harmful if inhaled or swallowed and may cause skin or eye irritation.
    • Do Not use test strips after the expiration date (printed on the vial) or the discard date, whichever comes first, or your results may be inaccurate.

AW 07295104 B